|
||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||
These are examples of what is on Bumper Stickers Vol. 1
|
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
Should you receive any complaints about the sticker you have put on your car etc. ask the complaint if to go to the following email address…….…. ididntdoit@woops.com
|
|
|
Instructions First From Your computer go to the Printer and select properties (this will vary from printer to printer) and then select Printing Preferences and then Page setup. In the area where it says page size select custom and set the Width to 65mm and the Height to 210mm Select Landscape, click OK. click Apply, click OK, Click OK. You have now setup a custom sheet for your bumper sticker. Second Use the CD to choose which sticker you want and jot down the folder and image number (eg. Folder “style 1” image number “14”) Third From MS Publisher (use another program if your more familiar with that) Click on File >Page setup>Layout (Depending on the printer) In the box below Publication type, you should click on Custom Set you page size to 21cm Wide and 6.5cm height Click on OK From the menu bar select “Insert” Click on Picture > from file > select you CD Rom and fine the image you jotted down and click on it and then on insert You’re ready to print you bumper sticker. (if your not sure that you have set everything up ok cut a bit of scrap paper to the same size as you sticker paper and try a test run) Finish As Your Laser, inkjet printer etc doesn’t use water resistant ink you will need to protect your print. You can do this with a couple of coats of a spray lacquer/water proof spray or you can use clear contact film. Any of these are available readily from a craft shop, hardware store or discount variety store, some supermarkets and newsagents.
|
|
